concept - eNone: similar 3D structures 3-molecule mix
Goal: a mix of eNone and/or 3 eNone-like modifiers that:
- consistency -works with a greater variety of people “across the board”
- forgiving - reduced OD at the higher range
- memorable - enhanced positive fallout-like effects
- efficient - very little needed to see effects
- works well on its own as an eNone replacement
given the success of P75 and eNone as attention-getters, I feel this is an area rich with potential.
appropriate doses of P76 and P77 have not gotten much attention even in isolation, and even where they have, often not at suggested dosages, however 3D structure suggests potential.
MHarris: “I recommend the lowest dosage we sell for P75 to P77”…“may actually end up being stronger than androstenone … so caution should be exercised. I’d start very low with these”
as with eNone, the appropriate range for testing likely begins in the nanogram range per spray. Multiple sprays over a large surface area works best for the characteristics of eNone.
I’m quite curious to find out more about the combined effect of these three at low doses in various ratios, in combination w/ eNone.
The idea of combining eNone with modifiers is not new.
625 ng = 1
1.25 mcg = 2
3-mollecule mix ratios (1 through 7)
the idea is to have around 5 mcg of modifiers (from 2 sprays)
1:1:1 / 2:2:2
2:1:1
1:2:1
1:1:2
2:2:1
2:1:2
1:2:2
combining each of these with eNone at low, medium, or high levels.
or alternatively as an eNone replacement.
This yeilds dozens of combinations, with different effects at 1-3 sprays of modifiers.
Testing could take years to really get a feel for differences in the combos.
Perhaps the mcg levels need to be altered, but I like the overall idea of making these mixes.